LOGAN GRAPHIC PRODUCTS, INC · Frame fitting and backing tools
Logan F60 dust-cover paper trimmer
What this tool is for
The Logan F60 trims the paper dust cover along the back of a frame. Its approximately 3/16-inch offset gives you a reference when you want a consistent paper edge set in from the frame perimeter. Compare that inset with the area where the paper can adhere on the actual frame.
Check the back edge of the molding before buying. If its shape makes it hard to follow one continuous edge, test on a spare frame or molding offcut before planning around this trimmer.
Specifications
- Brand
- LOGAN GRAPHIC PRODUCTS, INC
- Tool type
- Dust cover trimmer
- Model
- F60
- Working material
- Paper dust cover
- Trim inset
- About 3/16 in from the outside frame edge
- Replacement blade
- Logan #270
- Listed package
- Trimmer and three #270 blades
- Amazon.com reference
- B0FHHXKQHB
Fit and buying advice
Check whether the back edge can guide the tool and leaves sufficient paper contact.
Compare options in this department ↗
Documentation
Questions about this tool
Will this trim a foam or rigid backing board?
The F60 is for trimming paper dust covers. Size rigid backing to the frame earlier in the job, with a tool documented for its material.
Which spare blade fits the F60?
Logan specifies #270. This is also the blade Logan lists for several other tools, so check your existing supply by code.
Where in the job does the trimmer come in?
Use it after you have fitted the contents and attached the paper cover. The point driver belongs earlier in the fitting sequence.
